Configure D-Link Xtreme G DI-624 as an Access Point. This D-Link DI-624 come with 4 ethernet port, just connect a network cable to one of these port to your switch and it connected to your LAN. 1. Select Wireless Menu Open your browser and go to 192.168.0.1 Type admin as username, leave the password blank on the login screen and click ok. In the left panel, select Wireless to open the Wireless Settings. 2. Change SSID Replace the SSID the familiar term to you. I use azm for this setting. 3. Security Setting For Security, select WEP. Select Shared Key for Authentication and type in your key. For this example I use Key1:1111111111 Then click Apply. D-Link AirPlus Xtreme G DWL-2100AP as a Repeater It is recommended to make a direct wired connection from your pc to DWL-2100AP. Also make sure the D-Link DI-624 is on and in range. 1. Select Wireless Menu Open your browser and go to 192.168.0.50 Type admin as username, leave the password blank on the login screen and click ok. In the left panel, select Wireless to open the Wireless Settings. 2. Change Mode For Mode, choose Ap Repeater 3. Security Setting Choose Shared Key for Authentication Under Key Setting, type in 1111111111 for First Key 4. Site Survey Under Site Survey, click Scan button. After a while a list of available wireless Access Point will appear. Select the SSID you just configure on the D-Link DI-624, in my case, it's azm Click on apply. Configure Client PC Put the DI-624 and the DWL-2100AP at your preferred location. In my case, the DI-624 is in building A and connected to other switch so that it will have access to my wired LAN. The DWL-2100AP is located in building B together with one pc with wireless adapter. On the client pc, scan for available wireless network and choose your preferred network. You should be able to browse and access the entire network.